 |
|
Quality Assurance & Testing |
| |
Quality Assurance being the focus area, C.D Engineering Company has acquired inspection techonology & people competence to conduct testings & inspections. Latest inspection equipment & testing facility strengthens our company to deliver quality assured products towards meeting customer expectations in compliance with various International & National standards.
Our infrastructure facilitates third party inspections in line with customer requirements delivering right products. Customer approvals demonstrate our capability to perform inspection with proven methods & techniques. |
|
| Inspection Facility |
| |
NON-DESTRUCTIVE TESTING |
DESTRUCTIVE TESTING |
|
|
|
|
| |
To detect internal flaws, their location, orientation and magnitude thereof. |
To assess the ductility of material at ambient to sub zero temperature depending on the material specifications. |
| B. Magnetic Particle Testing |
|
B. Hardness testing |
|
|
This test detects surface & sub-surface defects and is performed with following methodologies:
• Dry Powder
• Wet Methods
• Wet Fluorescent Method |
To establish the resistance to penetration offered by material under testing. |
| C. Dye Penetrant Testing |
|
C. Tensile Testing |
|
|
This test detects surface and sub-surface defects. |
To ascertain the yield & ultimate strength regarding material ductility in terms of percentage elongation and reduction in area. |
| METLOGRAPHICAL TESTING |
D. Bend Testing |
|
A. Microstructure
B. Macrostructure |
To determine the ductility of the material during cold working. |
IGC (INTER GRANULAR CORROSION) |
CHEMICAL TESTING |
This test detects the susceptibility of the material to inter-granular attack under various conditions laid down in ASTM-A 262. |
| A. Positive Material Identification |
To establish that the manufactured product is in conformity with the specified chemical composition. |
| B. Product Checking |
| PA is performed on random basis on a lot forged and heat treated in single batch and pertains to the same heat number of the raw material. |
|
| | | | | |
